richmond car care

  Car Care
  Book Appointment
  Oil Change
  Brakes
  Transmission
  Tune Up
  Cooling System
  Tires and Wheels
  Fuel Injection
  Maintenance
  Fleet Maintenance
  Testimonials
  Maintenance Tips
  Contact Us

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

car care vancouver

Transmission Service - All Tune Car Care Centre

vancouver transmission service At All Tune Car Care Centre we do high quality diagnosis and transmission repair at a better price than most other transmission repair shops. All of our work is "as necessary." Each transmission repair is evaluated as to the nature and extent of damage in order for us to give you the best solution for each customer. You will be presented with as many options as possible to resolve any problem that you may have. Each transmission problem is unique and has to be addressed on an individual basis. With that in mind, we will need to have the vehicle at our facility to properly evaluate any transmission concern. Book your appointment today.

Come in today and have your transmission inspected free at All Tune by our certified auto mechanics.

Transmission Self Diagnostic Aid

1. The first thing you should do when you suspect any transmission problem is to check the transmission fluid level and condition. The engine should be running with the transmission in "PARK." With Chrysler products, check level with the transmission in "NEUTRAL" with the parking brake set and engine running.
Tip: Always insert the dipstick 2 or 3 times, look at both sides, and check for a consistent reading.

2. If the fluid level is low, fill to the proper level and test drive the vehicle. If the abnormal symptoms are gone, your primary problem is a leak. Continue to monitor the fluid level, add as appropriate, and have the leak source diagnosed before additional problems occur. NOTE: A slow leak is worse than a big leak! A slow leak will allow the transmission to operate until the level is low enough to subject the unit to low fluid operation which will cause excessive wear! A big leak will certainly get your attention and usually results in little or no internal damage.

3. There are numerous transmission seals, gaskets, and o-rings that can leak. Therefore, a visual inspection is necessary to determine leak sources before an estimate for repair can be made.

If the fluid level is okay, and you still have a transmission problem...

1. Check for any transmission related linkage, vacuum hoses, or electrical connections that may be lose or disconnected. One of the most common problems are corroded battery terminal connections. Clean terminals are particularly important for late model computer controlled transmissions!

2. The following is general information regarding computer controlled transmissions.

Late model transmissions are controlled by a computer that operates shift and pressure control solenoids inside the transmission. Therefore the computer needs to be electrically scanned by a transmission professional to determine if any electronic control problems exist. When the computer "sees" any parameter from various sensors that do not fit established criteria, the computer will set a code for each error, which will be evident by a "check engine" and/or a flashing overdrive light. However, there are some errors that will be present that the computer will not sense because they are within the normal range. In that case, the system has to be diagnosed to determine if applicable sensors or other electrical components are performing incorrectly and creating an abnormal transmission operational response. The following sensors are usually part of the transmission: MPLS (Manual Linkage Position Sensor), input and output speed sensors, shift solenoids, governor sensor, etc.

Please be aware that some sensors are not part of the transmission itself, but in other areas of the vehicle. These include the TPS (Throttle Position Sensor), the MAS (Mass Airflow Sensor), MAP (Manifold Absolute Pressure sensor), PCM (Power Control Module or Computer), DSS (Differential Speed Sensor), CTS (Coolant Temperature Sensor), IAT (Intake Air Temperature), etc.

Also, be aware that a scan done at a "parts store" will not show all of the information necessary to form a conclusion about an electrical control problem. A lot of problems in the control system do not set a code in the computer, but can still cause transmission problems.

When the shifts of a computer controlled transmission are excessively firm, the pressure regulator may set to maximum pressure by the computer if it senses a problem from one or more sensors.

The results of this diagnostic testing should indicate whether the problems are in the control system, the transmission, or both.

When the ignition key is cycled, the computer is reset and will control the transmission normally until an error is registered. Then the transmission will be placed in "limp" mode (2nd gear) again.

We have found that it much better to evaluate the situation "hands-on" than to speculate on the phone. Over the years, we've been amazed at the number of times the conclusion made before seeing a vehicle changes after it is inspected and the situation is professionally diagnosed.

book car care appointment


Always be sure to follow your manufacturer transmission maintenance guidelines to insure that your vehicle is always performing to its full potential.

AllTune Car Care Centre - Honest and Reliable Transmission Service and Repair.

 

all content property of AllTune Car Care Centre 2008 - website optimization Canadian iManagement


vancouver car care - oil change vancouver - brake service vancouver - vancouver transmission service - tune ups - cooling system service
radiator service vancouver - vancouver tires and wheels - fuel injection service - auto service vancouver - online car care coupons
domestic auto service vancouver - import auto service vancouver - book car service appointment vancouver - contact car care service vancouver

vancouver car care - on-line car care coupons